MANUFACTURING ENGINEERING

Engineering Your Advantage.
From Drawing to Stable Production.

We optimize gear design, reverse-engineer existing samples, route processes, and control cost—bridging the gap between design and production before machining begins.

NDA Available Before Sharing ISO Certified Management System Full Quality Reports

Our Engineering Services

Looking for a Feasibility Analysis or Cost Estimate? → Secure Project Initiation
01

Design Optimization for Manufacturability

Design Optimization / DFM

Share your sketches, gear parameters or drawings. We review gear geometry, tolerance stack-up, material and heat treatment, then optimize for strength, fatigue life, noise performance and manufacturing cost.

  • Gear geometry & tolerance review
  • Material & heat treatment recommendation
  • Root strength, fatigue, noise and assembly fit optimization
  • Production-ready drawing + formal DFM report
InputSketch / gear specs
ActionDFM review & tolerance rationalization
OutputOptimized drawing + report
02

Reverse Engineering: From Sample to Drawing

Reverse Engineering

No technical drawings available? Send your original gear sample. We extract critical design data, reconstruct gear parameters, and deliver a drawing/CAD package ready for reproduction, replacement or performance upgrade.

  • Sample inspection & parameter reconstruction
  • Material, heat treatment and surface condition evaluation
  • Critical mating interface & tolerance definition
  • 3D CAD / 2D drawing / inspection report
InputPhysical gear sample
ActionScanning, parameter solving, CAD
OutputProduction-ready drawing
03

Process Routing & Production Readiness

Process Engineering

We translate the optimized design into a controlled manufacturing route. We define CTQs, custom fixtures, tooling and inspection checkpoints before machining starts, and hand over validated FAI for pilot production.

  • Process route selection based on load and cost
  • Fixture, tooling and CTQ control plan
  • Pilot run & first article inspection (FAI)
  • Ramp-up support and continuous improvement
InputFinalized drawing
ActionProcess planning & fixture design
OutputRoute sheet + QC plan + FAI
04

Design-to-Cost Optimization

Cost Engineering

Engineering decisions directly drive total cost. We adjust tolerances, material selection, heat treatment and process sequence to maintain required performance while lowering overall manufacturing cost.

  • Tolerance rationalization & material substitution
  • Reduce scrap, rework and cycle time
  • Value analysis / value engineering (VA/VE)
  • Cost-down roadmap for mass production
InputDesign & cost baseline
ActionVA/VE & process evaluation
OutputCost-down proposal

Our Engineering Workflow

Six connected steps ensuring a smooth transition from concept to production.

01

Concept / Drawing

Share your requirement

02

DFM & Design

Optimize manufacturability

03

Reverse Engineering

Reconstruct missing data

04

Process Routing

Define control plan

05

FAI / Pilot Run

Validate first article

06

Mass Production

Handover to machining

ENGINEERING CONFIDENCE

Backed by quality and confidentiality

Your drawings, specifications and samples remain confidential. Engineering outputs are tied to a controlled quality system—from DFM and FAI to full quality reports and traceable inspection.

See Quality Assurance System

NDA Available

Formal confidentiality before details are exchanged.

ISO Certified

Controlled processes from engineering to production.

Full Quality Reports

Visual quality and inspection records before shipment.

Traceable Quality

Advanced inspection equipment and traceable records.

engineering support for your project

Need Help Moving Your Design Toward Production?

Whether you’re refining a design, evaluating manufacturability, recreating a component, or preparing for production, Davis is ready to understand your challenges and help identify practical engineering and manufacturing solutions.

Tell Us About Your Project

Share your project requirements, and our team will get back to you.

📎   Need to share drawings?