Introducing Gleason CMM Equpment 2026

1. Material Selection & Surface Engineering

Ultimate Strength Matching: High-toughness carburizing steels such as 18CrNiMo7-6 are recommended. Surface hardness should reach HRC60–62 with a carburized case depth of 1.2–1.8 mm. Core hardness should be maintained at HRC35–40 to withstand impact loads.

Surface Integrity Control: Post-grinding shot peening is necessary (coverage rate 200%+, Almen intensity 0.3–0.5 mmA) to reduce root stress concentration factors to below 1.3.

Anti-Scuffing Treatments: DLC coatings (thickness 2–3 μm) can increase the PV value limit by over 30%, suitable for line speeds exceeding 80 m/s.

2. Tooth Profile Dynamic Optimization

Profile Modification Algorithms:

  • Thermo-elastic Deformation Compensation: Should be based on FEA thermodynamic analysis. A typical modification amount = 0.5 × (δ_thermal + δ_elastic), where δ_thermal ≈ 0.02 × module × ΔT / 100.
  • Dynamic Profile Modification: Use parabolic + high-order harmonic superposition methods. Maximum modification can reach 15 μm for a module of 3.

Pressure Angle Optimization: A 25° pressure angle reduces contact stress by 12% compared to the standard 20°, but the contact ratio ε should be adjusted to exceed 2.1.

3. Lubrication System Design

Oil Jet Parameter Calculation:

Oil flow rate:

Q = 0.6 × b × m × n / 10000

(Unit: L/min, where b = face width in mm, m = module, n = speed in rpm)

Injection angles should ensure formation of an oil wedge:

Recommended: 30° ±5° on the drive side, 45° ±5° on the coast side.

Innovative Lubrication Approaches: Minimum Quantity Lubrication (MQL) systems with oil mist droplet size between 5–20 μm can reduce oil usage to 1/10th of traditional jet systems.

4. Dynamic Behavior Control

Tell Us About Your Project

Share your project requirements, and our team will get back to you.

📎   Need to share drawings?