Advanced Inspection Capabilities

High-Precision Gears & Shafts — Full Process Inspection

DIN 1–12 · 100% Traceable · In-House Laboratory

ISO 9001:2015 IATF 16949ISO/IEC 17025

Quality control throughout production — Raw Material, In-Process, Final Verification — to DIN & ISO standards.
Our physical & chemical lab and metrology center deliver 7 inspection dimensions for gears and shafts with 100% traceability.

1

Chemical Composition Analysis

Material grade verification — eliminate mix-up risk

OES Spectrometer — C, Si, Mn, Cr, Mo, Ni, V, Ti, P, S 10 ppm

Customer benefit: Verify material grade compliance before production — eliminate costly rework and scrap.

2

Metallographic Structure

Metallurgical Microscope — Grain size · Case depth · Core structure · Inclusions

Metallurgical Microscope — Grain size · Case depth · Core structure · Inclusions 

Customer benefit: Validate carburizing, quenching and tempering — ensure gear tooth hardness gradient and core toughness meet design requirements.

3

Hardness Testing

Tooth flank hardness · Core hardness · Journal hardness

Rockwell / Brinell / Vickers — Tooth flank ≥ 58 HRC · Core 30–42 HRC

Customer benefit: Ensure tooth flank wear resistance and contact fatigue strength — extend gear and shaft service life.

4

Gear Accuracy Inspection

Tooth profile · Helix lead · Pitch · Runout · DIN 1–12

Gear Measuring Center — Profile · Lead · Pitch · Radial runout · Cumulative pitch error

Customer benefit: Gear accuracy reports to DIN / ISO / AGMA standards — ensure smooth transmission, low noise, and high load capacity.

5

Dimensional Accuracy

Position · Concentricity · Runout · Shaft diameter

CMM — Coordinate Measuring Machine — Position · Concentricity · Runout · Diameter 

Customer benefit: Ensure assembly accuracy of gears and shafts — guarantee interchangeability with bearings, housings and mating components.

6

Surface Quality

Roughness · Roundness · Cylindricity · Contour

♦ Roughness Tester — Tooth flank · Journal Ra / Rz / Rmax

♦ Cylindricity Tester — Roundness · Cylindricity

♦ Contour Tester / Optical Projector — Tooth flank contour · Thread parameters

Customer benefit: Ensure surface quality of gear meshing flanks and shaft fit surfaces — reduce friction, minimize wear, extend service life.

7

Final Release — Full Gear Dimension Report

100% Inspection · DIN/ISO Compliance Report · Traceable to National Standards

pexels-yankrukov-7691730
Final Inspection · 100% documented pass/fail judgment

Customer benefit: Ensure surface quality of gear meshing flanks and shaft fit surfaces — reduce friction, minimize wear, extend service life.

In-house laboratory · All inspection equipment regularly calibrated · Traceable to national standards

Tell Us About Your Project

Share your project requirements, and our team will get back to you.

📎   Need to share drawings?